Additional electric rear wheel product brief introduction

This product is suitable for all kinds of manual wheelchairs, on the basis of the original installation into electric wheelchairs. Most of the motors in the market are fixed by screws, which cannot be directly installed on the manual wheelchair. Tenghui team has developed an electric rear wheel that can be directly installed on the manual wheelchair. The installation method is quick disassembly, convenient and lightweight, which reduces the physical burden of users when they travel, and also retains the manual mode. It can flexibly switch between manual and electric according to the user's specific application scenario, which is very convenient.

Instructions:
Remove the original rear wheel bushing and install Tenghui special rear wheel bushing.

Take the L or R direction motor and align quick release shaft with the rear wheel bushingInsert it. Make sure the bead pops out completely.Pay attention to the direction of the motor, the motor outlet should be in the rear, and the groove direction of the fixed seat on the motor should be upward.

Connect the controller connection cable of the electric rear wheel to the lower control of the controller.

There is a switch mark ON the front of the motor, and the operation mode of the motor can be adjusted by twisting the outer ring of the motor housing. The arrow is aligned with ON for riding mode, and the operation can be carried out forward and backward through the controller. The arrow is aligned with OFF for pushing mode, and the normal manual forward can be carried out.